Full switch test

Ok, so I needed to check every switch and input to MakeyMakey in one go, bit of a mess but everything went ok. Using a lot of temporary clips and hastily crimped cables, but it is still a prototype of course.

Close up of the mess, I may not end up with these switches in the end but they are serving well at the moment.

Common ground, thanks to a bit of foil and some clips, does the job for now. I ran out of clips so part of the test I had to hold the bare wire to the foil, something else to solve down the line.

Here is the MakeyMakey with every available input in use, as far as I know, total of 18. The empty block at the top are the slightly mysterious outputs, the only use I think I may have for that in this project is another flashing led when input is detected but that's not important for now.